STEP 5 CONNECTING THE MOTOR MODE SELECTOR AND DISPLAY WIRES Included in your accessory box is a special SHIMANO connector tool (the TL-EW300 tool). Use this tool (A) to connect the wires to your handlebar display. The tool helps to protect the plug and wire from damage. Slide the plug and wire into the tool as shown, ready for connection. Sitting on your bike, the cable that comes from the controller (mode selector) on the left-hand side of your handlebars goes into the first hole nearest to the stem (left-hand side), port number 1 (B). Align the plug into the port, then apply a small amount of pressure. There will be an audible click when the cable is fitted correctly. You may need to loosen and rotate the Display Selector slightly to help you gain access to the ports. The other cable that goes into your frame (C) (down to the drive unit/motor) attaches to the second port from the left, port number 2. 17
RkJQdWJsaXNoZXIy OTcxOTk3