STEP 3 CHECK REAR DERAILLEUR STEP 4 INSTALL HANDLEBAR The rear wheel comes installed on the Recon MX so all you need to do is check the torque on the rear wheel axle. Using your 5mm allen on your torque wrench tighten the rear axle and torque to 11Nm (A). Using the 4mm allen on your 3-way tool, loosen but don't remove the steer tube pinch bolts (B) allowing you to loosen the stem and rotate forward (C). Put the handlebars in place. Use the guidelines printed on the handlebars to help position them centrally and evenly. Check that the brake, shifter and dropper post cables have a nice flow and are not kinked or twisted in any way. Replace the stem faceplate and reinsert the bolts (D), first by hand and then with the 4mm Allen key. Gradually tighten the bolts, making sure that the bars are still positioned correctly and that the space between the faceplate and the main body of the stem is even. When tightening the bolts follow this pattern to ensure even clamping: top left, top right, bottom left, bottom right. Finish off using the torque wrench to 5Nm (E). 15
RkJQdWJsaXNoZXIy OTcxOTk3