2020 Parts Unlimited Tire

V-TWIN TOOLS www.dragnetweb.com BOLD MAGENTA part numbers are new for 2020 566 ROCKER BOX ALIGNMENT SCREWS • Prevents misalignment of cover, compromising of seal and potential rocker interference • Sold in pairs • Made in the U.S.A. TAPPET BLOCK/OIL PUMP TO CAM PLATE ALIGNMENT TOOL • Used to align oil hole from crankcase to tappet block • Can also be used to align rocker box bases on Evolution head (requires two tools) • Aligns Twin Cam oil pump to cam support plate; two required • Sold each • Made in the U.S.A. TAPPET POSITION HOLDING TOOL • Safely stores anti-rotation pins and tappets for proper and accurate installation • Locations of the tappets are marked on the tool; prevents damage after being removed from the engine • Made in the U.S.A. OIL PUMP SNAP RING INSTALLER • Allows easy installation of outer snap ring on oil pump shaft without stretching the snap ring • Fits Big Twin oil pumps (except Twin Cam/M-Eight) • Made in the U.S.A. TAPPET BLOCK/OIL PUMP ALIGNMENT TOOL • Big Twin tappet blocks do not have counter-bored bolt holes; therefore, when a tappet block is removed (or even just loosened) it should be reinstalled using an alignment tool to ensure that the lifters track properly on the camshaft • This tool makes the process quick and easy, ensuring the durability of your installation • Tool also aligns Twin Cam oil pump to the cam support plate; two tools required • Sold each • Made in the U.S.A. TAPPET OIL SCREEN PLUG TOOL • Used to remove the tappet oil screen plug • Removes oil screen without removing exhaust • Made in the U.S.A. OIL PUMP SEAL INSTALLER • Easily installs oil pump seal below gear surface for a no-leak fit • For use on all Big Twin aluminum oil pumps (except Twin Cam/M-Eight) • Made in the U.S.A. CRANKCASE OIL PASSAGE DRILLING JIG • Used to install S&S oil pumps on early motor cases • Jig is made from steel and heat-treated for durability • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3801-0259 For 99-17 Twin Cam $72.95 PART # DESCRIPTION SUG. RETAIL DS-197077 For L76-17 Big Twin (except M-Eight) $23.95 PART # DESCRIPTION SUG. RETAIL 3801-0275 For all 99-17 Twin Cam engines and 00-20 XL and Buell (except 1125R) $62.95 TAPPET SCREEN PLUG TOOL • For use on 70-99 Big Twin (except Twin Cam) with slotted screw tappet oil filter screen cover • Designed for use with 7 / 16 ” combination wrench to allow for maximum rotation without touching engine cases • O-ring design retains the tool in wrench or socket • Flange design allows downward force to be applied to tool • Can be used without removing exhaust pipes on most bikes • Tappets should be serviced every oil change PART # DESCRIPTION SUG. RETAIL 3801-0002 Tappet screen plug tool $9.99 PART # DESCRIPTION SUG. RETAIL DS-197058 Snap ring installer $72.95 PART # DESCRIPTION SUG. RETAIL 3801-0261 For L76-17 Big Twin (except M-Eight) $15.95 PART # DESCRIPTION SUG. RETAIL DS-198638 For 70-99 Big Twin $33.95 PART # DESCRIPTION SUG. RETAIL DS-197059 Oil pump seal installer $97.95 PART # DESCRIPTION SUG. RETAIL DS-197009 Oil pump jig $51.95