2021 Parts Unlimited Tire

V-TWIN TOOLS dragspecialties.com BOLD MAGENTA part numbers are new for 2021 2021 TIRE & SERVICE CATALOG 591 OIL PUMP PSI TESTER FOR M-EIGHT • Bench test the Feuling M-Eight oil pumps, cycle the pressure relief valve, testing operation and assuring the valve moves freely, seats and seals each time, any leakage at the relief valve will reduce oil pressure • This tool allows the engine builder to know what psi the relief valve opens; the spring tension can be adjusted to achieve the desired pop-off psi • Tool includes: air regulator, 0 - 100 psi pressure gauge, plugs for water and oil cooled oil pumps, gasket and needed hardware • Feuling recommends the oil pump relief valve be seated and sealed from 0-30 psi with full pop-off at 50-60 psi • Proper relief valve seal will insure good hot idle oil psi and reduce oiling system cavitation and related pressure issues OIL PUMP SEAL INSTALLER • Easily installs oil pump seal below gear surface for a no-leak fit • For use on all Big Twin aluminum oil pumps (except Twin Cam/M-Eight) • Made in the U.S.A. OIL PUMP SNAP RING INSTALLER • Allows easy installation of outer snap ring on oil pump shaft without stretching the snap ring • Fits Big Twin oil pumps (except Twin Cam/M-Eight) • Made in the U.S.A. CRANKCASE OIL PASSAGE DRILLING JIG • Used to install S&S oil pumps on early motor cases • Jig is made from steel and heat-treated for durability • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3801-0328 For M‑Eight w/ Feuling oil pumps only $379.95 PART # DESCRIPTION SUG. RETAIL DS-197059 Oil pump seal installer $97.95 PART # DESCRIPTION SUG. RETAIL DS-197058 Snap ring installer $72.95 PART # DESCRIPTION SUG. RETAIL DS-197009 Oil pump jig $56.95 • Made in the U.S.A. NOTE: Fits Feuling oil pumps only; does not fit factory HD oil pumps.