2021 Parts Unlimited Offroad

FUEL/AIR SYSTEMS parts-unlimited.com 2021 PARTS UNLIMITED OFFROAD BOLD MAGENTA part numbers are new for 2021 1258 DISCLAIMER: NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES. SEE PAGE 4 FOR IMPORTANT EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND WARRANTY INFORMATION. PART # SUG. RETAIL 1020-2371 $249.95 POD-300 DIGITAL DISPLAY • Real-time fuel adjustment • Display channels real-time: RPM, TP, map position (when using map switch), duty cycle, fuel exchange, ignition change and wideband air/​fuel ratio (w/ WB2 or auto-tune connected) • Weather resistant for use in all conditions • Log channels saved to internal memory and can be viewed/​ analyzed with Dynojet’s powercore software • High-contrast display, viewable in sunlight • Includes CAN cable for attachment to Power Commander V, Auto Tune and Wide Band Power Commander NOTE: Not for use with Power Commander III USB. PART # SUG. RETAIL 1601-0423 $289.95 IGNITION QUICK SHIFTER • Allows any vehicle with up to four coils to have quick shifter functionality • Features the latest Intellishift ™ technology and provides the smoothest shifts of any stand-alone unit on the market • Kill times per rpm band and shift sensor activation point are adjustable • Includes Denso coil cap connectors for easy installation on many late model motorcycles; connectors can be removed for applications without this style of coil • Control box only; requires Power Commander shifter sensor DESCRIPTION PART # SUG. RETAIL Shift rod linear sensor (pull type) 1601-0013 $219.95 Shift rod linear sensor (pull type) for Power Commander V 1601-0246 276.95 Shift rod linear sensor (push type, includes mounting kit) 1601-0014 219.95 Shift rod linear sensor (push type, includes mounting kit) for Power Commander V 1601-0247 276.95 DYNOJET QUICK SHIFTER (DQS) SENSORS USB/V • Races are won or lost in fractions of a second • Dynojet’s Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and performance riding applications • Shift rod pressure/​tension sensor kit is a universal sensor that mounts to the shift rod in either a push or pull configuration; requires modification of gear-linkage tie-rod • Linear travel sensor kit works with bikes that have no shift rod, or on those the shift rod sensor will not fit, by mounting one end to the shift lever and the other to a fixed point on the chassis; available in push or pull types with universal mounting hardware • Plugs directly into the Power Commander expansion port with no re-wiring required • Power Commander Control Center software lets you set engine dead time during upshifts and minimum rpm for system operation • PART #s 1601-0013 and 1601-0014 are “linear” sensors for PCIII USB • PART #s 1601-0246 and 1601-0247 are “linear” sensors for PCV NOTE: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/​pressure/​ tension sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel sensor, also move the shifter for an upshift. If movement is down, a pull sensor is needed. If movement is up, a push sensor is required. 1601‑0014