2021 Drag Specialties FatBook

WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES dragspecialties.com SECTION 6 All part numbers in BLUE are new for 2021. 597 DISCLAIMER: NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES. SEE PAGE 5 FOR IMPORTANT EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND WARRANTY INFORMATION. See OLDBOOK For Early Model Applications PART # DESCRIPTION SUG. RETAIL 1020-0949 For 08-13 FLHT/​FLHR/​FLTR/​FLHX $349.00 PART # DESCRIPTION SUG. RETAIL 1020-0948 For 01-11 Big Twin and 07-13 XL (except 08-11 Touring models) $292.00 TWIN TUNER II • Twin Tuner II has all the features of the original Twin Tuner and includes ignition timing control capability • Easily adjusts the OEM Delphi fuel-injection and ignition to match the requirements of performance parts including high-compression pistons/​heads, camshafts, free-flowing exhausts, and low-restriction air filters – add 30% or subtract 20% fuel and retard spark timing up to 10° • You can use the mode and up/​down pushbutton switches to make fuel trim adjustments in the rpm and throttle position ranges required by most applications; the fuel trim value is displayed on a bright daylight-readable LED display • The Twin Tuner also has an advanced mode, using the optional USB Interface and PC Link Tuner software to make precise fuel adjustments and allows independent adjustments to the front and rear cylinders • May be compatible with other controller maps PART # DESCRIPTION SUG. RETAIL 1020-2033 For 01‑07 Big Twin and 07 XL models w/ 36‑pin connector $571.00 PART # DESCRIPTION SUG. RETAIL 2101-0075 USB interface kit $99.00 FI-TO-CARBURETOR CONVERSION KIT • Allows most Big Twin and XL models with Delphi EFI to be converted to a carb fuel system • Uses existing wiring harness with no modifications needed • All functions of the turn signal/​security module continue to function normally • Includes required software and detailed instructions • Made in the U.S.A. NOTE: Requires the separate purchase of USB interface PART #2101-0075. NOTE: Requires the separate purchase of a Pingel fuel injection-to-carb tank fitting kit PART #0705-0031. • Easy plug-in installation and setup, with no splicing, cutting, crimping or bulky interconnections • Compact size – only 4” L x 2” W x .5” H • Compatible with Twin Scan II+ Tuning Aid – install the Twin Scan II+ and ride the bike, then copy the air/​fuel ratio corrections calculated by the Twin Scan II+ into the PC Link Tuner software 2101‑0075 1020‑2033