2020-21 Drag OldBook

WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATEFRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES www.dragnetweb.com All part numbers in BLUE are new for the OldBook. SECTION 8 472 See FATBOOK For Late Model Applications PART # DESCRIPTION SUG. RETAIL 1 5 / 8 ” SYSTEMS 1120‑0249 For 90‑98 FLT, 90‑93 FXR $773.95 1120‑0247 For 90‑99 FXST/​FLST and 94‑98 Dyna models 773.95 3” ELECTRIC START SYSTEMS 1120‑0251 For 90‑99 FXST/​FLST models 1,861.95 PART # DESCRIPTION SUG. RETAIL 3” ELECTRIC START SYSTEMS (CONT) 1120‑0252 1 For 86‑89 FXST/​FLST models $1,861.95 1120‑0245 For 91‑98 Dyna Glide models 1,992.95 1120‑0265 For 90‑93 FXR models 1,992.95 1 Requires the use of a 90‑06 style starter (sold separately). 8MM BELT DRIVES WITH LOCKUP CLUTCH • 1 5 / 8 ” kits include front pulley, belt, clutch hub, clutch basket and clutch set (consists of two half plates, four full plates and five steel drive plates) • Direct bolt-in applications • 3” electric start kits include front pulley, belt, clutch hub and clutch basket and clutch set (consists of two half plates, four full plates and five steel drive plates), 6061-T6 billet motor plate, outside guard and polished pulley cover • All systems come with the Quiet Clutch and ball-bearing lockup design pressure plate • Lockup design applies extra pressure to the clutch plates for positive engagement with no clutch slippage • No increase in lever pull effort • Rear pulley has a 40mm, double-row bearing with an inner stress-proof steel clutch hub to support the clutch • Replacement components available separately; see pages 473-474 • Made in the U.S.A. NOTE: 3” systems are not designed for use with floorboards. NOTE: Not for use with offset primaries. PART # DESCRIPTION SUG. RETAIL 1120‑0171 Retrofit kit $747.95 OUTBOARD BEARING RETROFIT KIT • This kit has been updated to eliminate the front pulley and engine shaft supports • The reason for this change is that many aftermarket components used on special-construction motorcycles do not allow proper alignment of the front engine and rear transmission shaft • Kit now supports only the rear shaft (which is all that is really required) to eliminate any problems of mis- alignment of the front and rear transmission shafts • Works with existing BDL 3” open belt drive kits for Softails and Dyna Glide models not incorporating an outboard bearing support (kits not enclosed within the OEM inner/​outer primary covers) • Includes outboard support plate, pulley covers and all necessary hardware • Made in the U.S.A. 1120‑0247 1120‑0252 1120‑0265